| Research on rapid planar printing method of micro-nanostructures based on meniscus-confined electrodeposition |
|
Xiaobo Liao1, Wukui Su1, Xuan Liao1, Wenlin Wu2, Lei Chen4, Xinai Zhao1, Zhiwu Wang3, Jian Zhuang2 |
1Key Laboratory of Testing Technology for Manufacturing Process, Ministry of Education, Southwest University of Science and Technology, Mianyang 621010, China 2School of Mechanical Engineering, Xi’an Jiaotong University, Xi’an 710049, China 3School of Mechanical Engineering, Taiyuan University of Science and Technology, Taiyuan 030024, China 4College of Engineering and Technology, Southwest University, Chongqing 400716, China |
Correspondence:
Zhiwu Wang, Email: wangzhiwu@tyust.edu.cn Jian Zhuang, Email: zhuangjian@mail.xjtu.edu.cn |
|
Received: 9 June 2026 • Accepted: 30 September 2026 |
| Abstract |
|
Meniscus-confined electrodeposition (MCED) has emerged as a significant research focus in micro‑nanofabrication due to its advantages such as low cost, versatile material compatibility, and economical processing. However, during MCED‑based planar printing, substrate unevenness can cause variations in the droplet morphology between the probe tip and the substrate, leading to deposition instability. To address this issue, this paper proposes a rapid planar printing method based on MCED. The method first utilizes the structural similarity between MCED and scanning electrochemical cell microscopy (SECCM) to perform AC‑mode SECCM‑based topographic scanning for obtaining the morphological height profile of the substrate. Subsequently, a singular value decomposition (SVD) plane‑fitting algorithm is applied to derive the parameters of the working plane, enabling real‑time vertical probe compensation during continuous planar printing. Finally, circular and alphabetic patterns with a diameter of 80 μm and a line width of 5 μm were successfully printed on a gold substrate. Experimental results demonstrate that the proposed approach effectively mitigates the influence of droplet morphological variations on deposition stability during MCED planar printing, providing a valuable reference for promoting the broader application of MCED in micro‑nanofabrication. |
| Keywords:
MCED, Micro- and nanomanufacturing, SECCM, SVD plane fitting |
|